Punch Station
Capacity: 1" hole in 1/2" material.

The "automatic urethane stripper" has two functions. It holds the material down to prevent the material from deforming and strips the material from the punch.

The punch station also comes with an adjustable lower stripper plate. This crowds the punch so you can punch holes close to the material edge and still have the material strip off properly.

The punch table is stamped with indicator marks for fast, accurate and easy set up. The table guide and back gauge are standard as is a set of 6 punch and dies, from 5/16" to 1".

The punch station uses standard fig. 20 punches and fig. 59 dies.
These are available in 1/8" to 1 1/4" sizes for square, round and oblong holes.